danwilley
Member
I have a complex assembly that I cannot get to move and operate. I can remove (suspress) various sub-assemblies and eventually the remaining parts do move (jerky in motion).
My question... assuming the overall assembly is properly formed, flexable and constrained (not over constrained), what is most likely the cause of this loss of motion? Under-powered CPU, Not enough main memory, Under-powered graphics card? Other?
Or, should a properly formed assembly always move regardless of the computer system but maybe only in jerky motion? (Which might imply my assembly is not properly formed.)
Thanks,
Dan
My question... assuming the overall assembly is properly formed, flexable and constrained (not over constrained), what is most likely the cause of this loss of motion? Under-powered CPU, Not enough main memory, Under-powered graphics card? Other?
Or, should a properly formed assembly always move regardless of the computer system but maybe only in jerky motion? (Which might imply my assembly is not properly formed.)
Thanks,
Dan