Joint Creator

[Tungsten]

Hi,
I've used Atom 3D for a couple of years but looking to upgrade to Design Professional. I had a trial a few month back but never properly checked it out.

I know that the joint creator script can make finger joints at 90 degree corners but can it make joints if the two parts are at an angle, lets say 45 degrees.

I have started designing my own laser models that use finger joints and have been using Onshape. Onshape does these joints great but I hate the fact that it is cloud based. I would really like to start using Alibre Pro for this. An example of the joints can be seen in the photo.

Thanks

 

[NateLiquidGravity]

It does not currently support that ability but could be upgraded by someone to support more. It would not be a quick task to figure out solutions to all the possible cases: different angles, different thickness walls, different length edges...

 

[Tungsten]

Thanks for that. I've since upgraded to Pro and busy trying thinks out.