pridbor
Senior Member
I'm a metric guy, so I usually just change from the installation "Inch way" to Metric as default by checking that small box in the lower-left corner.
However, unless I'm just not knowing what I'm doing, I have tried this "trick" several times on different drawings, and it keeps coming up with Inch measurements.
Not a biggie, but it would be nice if I could change permanently to metric for parts and drawings alike, BTW I do think that the part setting is OK.
Preben
However, unless I'm just not knowing what I'm doing, I have tried this "trick" several times on different drawings, and it keeps coming up with Inch measurements.
Not a biggie, but it would be nice if I could change permanently to metric for parts and drawings alike, BTW I do think that the part setting is OK.
Preben