jcdammeyer
Senior Member
I can use 3D Horizontal finishing to create a tapered hole. But the outside perimeter ends up being horizontal no matter what I try. I must be missing something but what? The attached photo shows how the tool path goes down in a purely vertical fashion while the pat is tapered.
I've added the part. It's a simple 1/2" plate to be cut out of MDF. The inner hole has the taper. The perimeter doesn't. If I try any of the 3D operations it just mills out the hole even though I've selected the outer segments.
What's the trick?
Thanks
John
I've added the part. It's a simple 1/2" plate to be cut out of MDF. The inner hole has the taper. The perimeter doesn't. If I try any of the 3D operations it just mills out the hole even though I've selected the outer segments.
What's the trick?
Thanks
John