wsimonton
Senior Member
Is there a way to mirror the attached Sheet Metal Part? I can mirror the features to create a mirror of the Part but then "cutting" or removing the features mirrored presents issues - I tried the "Dimple Cut" which removed the flat areas but left the "cylinders" of the part even with a 1" "cut" from the "flat" side.
Or do I have to create the Left and Right Hand separately? Help was not helpful.
Created in Geomagic Design Version:[ 2015.0.1 ] 64-bit
Or do I have to create the Left and Right Hand separately? Help was not helpful.
Created in Geomagic Design Version:[ 2015.0.1 ] 64-bit