Model railway roof curves

[spiritdesign]

Here's a late entry into the "How To" conundrum of the Victorian rail car roof profile. After some careful study it looks to me like the end was a sweep cut to produce the curve on the end above the door.
I tried to follow the drawing as close as possible while tracing. Getting the images at the same scale was a challenge, I think I got them pretty close.

Hi Harold, thank you for the file but my AlibreV27 Atom can't step back thru the file as it's non-editable. Chris

 

[Model Engineer]

Put some curves together. I forgot about how specific the lofting setup needs to be. I've been so used to not worrying about tolerances, curve polarities, degrees, etc. Would be good to see screenshots of the curves and loft menu for some of us that are off a few versions. This one's a good exercise. I need to go through the documentation again.