Kugelsicher
Member
More Sketching Enhancements....
1. Add an option for turning on a "Realtime Dimenison/Coordinate Box" that would show up whenever you selected any feature command. This box could/should also show the exact coordinate position of the pointing device whenever there was no feature selected.
2. To go along with #1 above, add a "snap increment" command, so that the dimensions in the "Realtime Dimension Box" would increment/decrement in the amount set by the "snap increment" command, as you moved your pointing device to make the feature bigger/smaller, longer/shorter, etc.
- This "snap increment" command would also cause the pointing device to snap to an exact coordinate position based on the "snap increment" value, as you moved your pointing device around in Part, Assembly, and Drawing modes.
The above should not replace the existing ability to "edit" a feature dimension.
Hope I am making myself clear, here.
Thanks for listening and taking our suggestions!!
1. Add an option for turning on a "Realtime Dimenison/Coordinate Box" that would show up whenever you selected any feature command. This box could/should also show the exact coordinate position of the pointing device whenever there was no feature selected.
2. To go along with #1 above, add a "snap increment" command, so that the dimensions in the "Realtime Dimension Box" would increment/decrement in the amount set by the "snap increment" command, as you moved your pointing device to make the feature bigger/smaller, longer/shorter, etc.
- This "snap increment" command would also cause the pointing device to snap to an exact coordinate position based on the "snap increment" value, as you moved your pointing device around in Part, Assembly, and Drawing modes.
The above should not replace the existing ability to "edit" a feature dimension.
Hope I am making myself clear, here.
Thanks for listening and taking our suggestions!!