New enhancement requests.

[wathavy4]

Hi.
These are minors not major but as I complained in the thread, I have to create each enhancement request so these are supported by all or some of you, too.

Please have a look at these and if you like it, please vote.

http://feedback.alibre.com/forums/16127 ... ?ref=title

( viewtopic.php?f=1&t=11276&p=67525#p67525 )

http://feedback.alibre.com/forums/16127 ... ?ref=title
( viewtopic.php?f=10&t=11274 )

Thank you for your attention.

Reference:
viewtopic.php?f=1&t=11302

 

[NateLiquidGravity]

FYI one of the linked forum topics is on sheet metal cuts and doesn't match the the request :wink:

 

[wathavy4]

Thank you,Nate.
I fixed them.

 

[wathavy4]

I was thinking these are new.

But I found this in my request record 'Escalated to Dev'.

Please vote for this enhancement. It's been ignored for over 2 years by today.

http://feedback.alibre.com/forums/16127 ... ?ref=title

 

[wathavy4]

Here is another one on P.C.D center lines.

 

[wathavy4]

Or this.

CaseNumber: 00027603 Created On: 2/2/2010
Status: Escalated to Dev Type: Problem
Subject:
Quick constrain tool behavior.
Description:
Hi. The quick constrain tool is a great tool you Alibre created. But the pity thing is that requires Space Navigator to let it work finely. Also it sometimes does not work fine. Please look into the Forum thread. viewtopic.php?f=10&t=10488&st=0&sk=t&sd=a The model is well done with no erroneous constrains but to let the quick constrain tool to work, one cannot rotate view using mouse. Or the work around is shown in the youtube. http://www.youtube.com/watch?v=VdIUqNFjtH8 Please examine the reason why this tool not working as expected and fix the issue. Thank you!
Upload a file (5 MB Limit):

Do I regard this enhancement.......No.

 

[wathavy4]

Sorry that there was a wrong link with my Center mark insertion enhancement request.

This is the right one.
Please vote!
http://feedback.alibre.com/forums/16127 ... ?ref=title

And thank you for those who voted for the Engineering expression issue.
http://feedback.alibre.com/forums/16127 ... ?ref=title