Hi,
I'm trying to create a simple tapered cylinder/tube. e.g. it's 3" long and tapers from 2" diameter at one end to 1" diameter on other end. In Blender, it had a tool to add a cone, where you specify starting diameter, ending diameter and length... Using Atom3D, I was thinking I could start with a circle of 2" dia, extrude it to a length of 3", then edit the diameter of one of the ends and change it to 1". But when I do that, both ends get resized and it remains a cylinder... I'm sure I'm just missing something simple...
TIA,
Mike
I'm trying to create a simple tapered cylinder/tube. e.g. it's 3" long and tapers from 2" diameter at one end to 1" diameter on other end. In Blender, it had a tool to add a cone, where you specify starting diameter, ending diameter and length... Using Atom3D, I was thinking I could start with a circle of 2" dia, extrude it to a length of 3", then edit the diameter of one of the ends and change it to 1". But when I do that, both ends get resized and it remains a cylinder... I'm sure I'm just missing something simple...
TIA,
Mike