JST
Alibre Super User
When using "offset free" to get a part parallel to a plane, such as the XY or YZ plane, if the part goes to the wrong side, persistently, no matter what position you put it close to, there seems to be no way to reverse it.
The support needs to face the other way, but using "offset free" with the base plane does not allow any choice as to where it goes.
Should that be true?
I tried order of selection and other things. Usually it will go the shortest move, but not this time, regardless of MM, and positioning, etc, it always went as shown.
The support needs to face the other way, but using "offset free" with the base plane does not allow any choice as to where it goes.
Should that be true?
I tried order of selection and other things. Usually it will go the shortest move, but not this time, regardless of MM, and positioning, etc, it always went as shown.
Last edited: