Part Generator Tab ?

[Alexander]

Hi,

Whilst waiting for an assembly to load I noticed this Part Generator tab on the ribbon which I don't recall seeing before.
Once loaded it disappears?

Anyone else seen this or am I missing something very obvious :?

 

[jhiker]

I noticed this for the first time yesterday and wondered what it was. It disappears once the assembly has loaded :shock:

 

[Alexander]

Update

My assembly is now corrupt and will not open fully.
This all happened after trying to create a 3d section view, which did not work and just went to a blank black screen. I had to force a shutdown and when I tried to re-load and all my tabs are greyed out, can't do anything with it.
I have had to roll back to a previous version (thank you MFiles) and have had this problem before when trying to create section views.

V16 does seem to be very sluggish compared to previous versions, I actually thought I installed the 32bit version by mistake. :roll:

As for the Part Generator tab.............. :?:

 

[DavidJ]

Long story behind the Part Generator Tab - really nice new functionality that was promised a long time ago, now will not be implemented. Great shame really.

I'm sure the interface will be tidied up to remove this reminder...