DDoerschuk
Member
Part suddenly has no endpoints, can't be dimensioned
I'm running Expert version 10,0,1,10059. I've got a part that has gone through many revisions. I only edit it in 2D sketch mode. It has always been well behaved. Suddenly, it's acting very strangely:
1) All the existing elements (lines, arcs, etc.) have no end-points. The little blue dots, right? Not there. If I randomly draw a new line, it appears correctly with end-points.
2) Nothing can be dimensioned. Try to dimension an existing line, and the line highlights, but never dimensions. A new line, with end-points, dimensions fine.
3) Drawing new lines, where you start by connecting to an existing intersection, produces wildly varied results: sometimes the line ends up starting somewhere else, sometimes it starts OK and then tries to align with something in the sketch that doesn't seem visible to me.
I have hopefully accidentally set some configuration option to a crazy value during this prolonged editing session. I've rolled back the repository version several days, and rebooted the machine, but to no avail.
Can someone point me in the right direction?
Thanks so much!
Dave
I'm running Expert version 10,0,1,10059. I've got a part that has gone through many revisions. I only edit it in 2D sketch mode. It has always been well behaved. Suddenly, it's acting very strangely:
1) All the existing elements (lines, arcs, etc.) have no end-points. The little blue dots, right? Not there. If I randomly draw a new line, it appears correctly with end-points.
2) Nothing can be dimensioned. Try to dimension an existing line, and the line highlights, but never dimensions. A new line, with end-points, dimensions fine.
3) Drawing new lines, where you start by connecting to an existing intersection, produces wildly varied results: sometimes the line ends up starting somewhere else, sometimes it starts OK and then tries to align with something in the sketch that doesn't seem visible to me.
I have hopefully accidentally set some configuration option to a crazy value during this prolonged editing session. I've rolled back the repository version several days, and rebooted the machine, but to no avail.
Can someone point me in the right direction?
Thanks so much!
Dave