barrykingwill
Senior Member
Problem with 3D Sketch path Boss Sweep
I have this single 3D multibend, multiplane 3D sketch as the sweep path for a (763mm Diameter Pipe) Boss Sweep. It gives me an error saying "can't compute top curve". I cannot see what is wrong. I have tried a different (smaller diameter pipe to extrude but no change)
Either a thin wall sweep or a Solid Boss Sweep would do me fine right now.
Please see photo of pipes from which measurements were taken, as well as the simple Alibre Part attached (or in Binaries)
Any help would be hugely appreciated as I am up against a deadline.
They need drawings of this pipe in order to change the design, and then re-manufacture the new one.
Thanks, Regards
Barry
I have this single 3D multibend, multiplane 3D sketch as the sweep path for a (763mm Diameter Pipe) Boss Sweep. It gives me an error saying "can't compute top curve". I cannot see what is wrong. I have tried a different (smaller diameter pipe to extrude but no change)
Either a thin wall sweep or a Solid Boss Sweep would do me fine right now.
Please see photo of pipes from which measurements were taken, as well as the simple Alibre Part attached (or in Binaries)
Any help would be hugely appreciated as I am up against a deadline.
They need drawings of this pipe in order to change the design, and then re-manufacture the new one.
Thanks, Regards
Barry