I have Alibre Design Expert V25 64 Bit (Build 25037)
Last week I was using Alibre and was able to create a simple loft.
Now if I try it will not create a loft from even a square and a circle - I can place a square on the XY plan, create a plane offset to XY at a nominal distance, and enter a circle both fully defined. When I use the loft command between the two sketches it simply fails to work (no preview) and comes up error.
Is there something that has been disabled that would cause this,everything else seems to work. I shut system down and rebooted but made no difference.
I have tried creating the offset plane first , it makes no difference.
I am no expert ,but I am wondering if it is possible to have something corrupted and should I reinstall the software again.
As I said earlier It did work for me last week but now not.
Your advise would be appreciated.
Best regards
Bob Portmann
Last week I was using Alibre and was able to create a simple loft.
Now if I try it will not create a loft from even a square and a circle - I can place a square on the XY plan, create a plane offset to XY at a nominal distance, and enter a circle both fully defined. When I use the loft command between the two sketches it simply fails to work (no preview) and comes up error.
Is there something that has been disabled that would cause this,everything else seems to work. I shut system down and rebooted but made no difference.
I have tried creating the offset plane first , it makes no difference.
I am no expert ,but I am wondering if it is possible to have something corrupted and should I reinstall the software again.
As I said earlier It did work for me last week but now not.
Your advise would be appreciated.
Best regards
Bob Portmann
