IonSteve
Member
Howdy folks, and a Happy New Year to everyone.
As always, my most abject apologies if this has been covered previously, although I did search and didn't locate anything.
My question du jour: I'd like the extrude bosses to remember the last behavior I used. E.g. the cut boss default is "to depth" but 90% of my cuts need to be "through all" and I am a lazy, lazy person who has grown tired of the extra clicks required to drop the dialogue list down and select my choice.
If I were doing cuts on monolithic parts that had consistent depths it wouldn't make any difference, but I quite often have oddly shaped parts or parts on more that one plane that need a cut extruded "through all."
All the very best to everyone--
Steve
As always, my most abject apologies if this has been covered previously, although I did search and didn't locate anything.
My question du jour: I'd like the extrude bosses to remember the last behavior I used. E.g. the cut boss default is "to depth" but 90% of my cuts need to be "through all" and I am a lazy, lazy person who has grown tired of the extra clicks required to drop the dialogue list down and select my choice.
If I were doing cuts on monolithic parts that had consistent depths it wouldn't make any difference, but I quite often have oddly shaped parts or parts on more that one plane that need a cut extruded "through all."
All the very best to everyone--
Steve