rotating a feature...What "surfacing Tab"?

[TimoCAD]

Btw...that did exactly what I needed it to do. I was trying to do it the 'hard way'. Anyway, mission accomplished...thanks again!

I am feeling a bit stupid right now as I cannot figure out how to rotate a feature. The help section says it is within the Surfacing Tab, but I cannot even find the Surfacing tab. What am I doing wrong?

Does Atom have Direct Editing? If Yes, you can use it to move Features, in your case All Features of the part.

 

[Kurt64150]

Does Atom have Direct Editing? If Yes, you can use it to move Features, in your case All Features of the part.

I'm not sure what you mean by direct editing.

 

[DavidJ]

No - Direct Editing is not available in Atom3D.