Please could someone check this out for me. (Or use my file below if you have V24...) Thanks.
In a Part file
Draw a 2D Spline Curve by Reference Points.
Sketch l Insert l Point onto one of the intermediate Reference Points of the Spline.
Close and open the Part.
The inserted Point shows red for me, in the reopened Part, but is definitely not orphaned and follows edits to the Reference Point it was placed on.
In a Part file
Draw a 2D Spline Curve by Reference Points.
Sketch l Insert l Point onto one of the intermediate Reference Points of the Spline.
Close and open the Part.
The inserted Point shows red for me, in the reopened Part, but is definitely not orphaned and follows edits to the Reference Point it was placed on.