Sketches visible after feature

[dammerel]

Hi all,
I am sure if this was an issue in previous versions, but after a sketch is consumed by a feature should the sketch be hidden
See screen shot below, the red lines and the sketches

 

[Max]

No, generally it has never auto hidden consumed sketches.

Did you make the sketches or were they auto generated from the flange tool?

Ctrl+shift+K Goggles sketch visibility.

 

[dammerel]

Max,

I made the sketches. If I hide (Ctrl+shift+K toggles sketch visibility) then all the sketches and new sketches are hidden
if you make sketches visible, it becomes confusing with all the sketches.. does that make sense?
I never noticed this behavouus on previous versions - maybe I am wrong
Andrew

 

[OTE_TheMissile]

Been that way as far back as I can remember. Usually they camouflage themselves among the edges of the Extrude or Cut they create, but if you're removing material at the edge of the part or if the Sketch is a projection from a sheetmetal Flange, they end up visibly hanging out in space. But they've always been either all visible or all invisible depending on your visibility setting, whether they were involved with a feature or not.