I have created a simple part in Geomagic. When I save it as a STL file and then import it in Repetier to print, the size of the part is reduced significantly. The part is a simple round disc with a hole in the center. Outer diameter is 5/16 with a hole in the center of 1/8 and a thickness of 1/8. in order to bring it up to close to the correct size in Repetier I must enlarge it by 26 times its imported size. This gets it very close to the required dimensions.
Any suggestions would be much appreciated.
Thank you,
Leif
Any suggestions would be much appreciated.
Thank you,
Leif