I am using AD Expert 12.1...
Normally, when building assemblies, hovering the mouse over a part highlights various surfaces of the part. However, many times while applying constraints it kicks into some sort of mode where the individual surfaces are not highlighted; the entire part is highlighted.
I don't know if this is a bug, or I am inadvertently entering some sort of strange selection mode; one which I can't get out of.
At this point my only remedy is to close and re-open the assembly file.
Any ideas about this will improve my sanity...
Normally, when building assemblies, hovering the mouse over a part highlights various surfaces of the part. However, many times while applying constraints it kicks into some sort of mode where the individual surfaces are not highlighted; the entire part is highlighted.
I don't know if this is a bug, or I am inadvertently entering some sort of strange selection mode; one which I can't get out of.
At this point my only remedy is to close and re-open the assembly file.
Any ideas about this will improve my sanity...