jfleming
Alibre Super User
Hello, I have an imported STEP file from a vendor. Picture it as a dumbbell and I want to lengthen or shorten the "handle" in the middle. Is there any method for accomplishing this, while leaving the "weights" out at the end unchanged.
My only solution is to boolean subtract one half, save as X. Boolean subtract the other half, save as Y. Go in and make an assembly with a new piece in the middle and make it the new, correct length???
My only solution is to boolean subtract one half, save as X. Boolean subtract the other half, save as Y. Go in and make an assembly with a new piece in the middle and make it the new, correct length???