I am learning Alibre Design Expert V25.
I'm doing an exercise that uses an open loop shown to make an extrusion using the thin extrude.
When one hovers over Thin Extrude, one sees this:
But I get an error I can't do a thin extrude using the sketch with an open loop above. I'm doing it exactly like the example in my tutorial, and according to the manual.
What am I misunderstanding here?
Thanks.
I'm doing an exercise that uses an open loop shown to make an extrusion using the thin extrude.
When one hovers over Thin Extrude, one sees this:
But I get an error I can't do a thin extrude using the sketch with an open loop above. I'm doing it exactly like the example in my tutorial, and according to the manual.
What am I misunderstanding here?
Thanks.
