tube profiles in wireframe
Right now I'm looking at an assembly made of tubes and sheetmetal. Unfortunately, when I look at some of the tubes in profile in wireframe mode, I don't see the true profiles. I see lines denoting the full width of the top and bottom faces, but for the actual curved geometry, I get lines that are not at the full width of the tube.
Might this be an error?
Right now I'm looking at an assembly made of tubes and sheetmetal. Unfortunately, when I look at some of the tubes in profile in wireframe mode, I don't see the true profiles. I see lines denoting the full width of the top and bottom faces, but for the actual curved geometry, I get lines that are not at the full width of the tube.
Might this be an error?