BrianE.Evans
Senior Member
I have just been asked if I can do a few printed circuit diagrams .
I thought that before telling the client no, I should ask the question here. I can see using the Sketch on a sheet in drawing mode, however I would have to create all of the schematic symbols manually.
As for drawing traces I guess I could draw a base film in copper then keep cutting away at it using sketches.
Anybody have any Ideas on this , or would I be better off getting a program like EAGLE ?
Brian Evans.
I thought that before telling the client no, I should ask the question here. I can see using the Sketch on a sheet in drawing mode, however I would have to create all of the schematic symbols manually.
As for drawing traces I guess I could draw a base film in copper then keep cutting away at it using sketches.
Anybody have any Ideas on this , or would I be better off getting a program like EAGLE ?
Brian Evans.