schenman
Member
V9 Sketching bug
I just discovered that when you filllet a figure, it ignores the redius value if you click close the the corner of the figure. I was trying to create a 1" radius fillet and the ones that I clicked far away from the corner came out fine but the one that I clicked close the corner was smaller than 1 ". It was not like that in V8x
I will place a snapshot in binary.
http://www.alibre.com/forums/viewtopic. ... 1354#11354
Schenman
I just discovered that when you filllet a figure, it ignores the redius value if you click close the the corner of the figure. I was trying to create a 1" radius fillet and the ones that I clicked far away from the corner came out fine but the one that I clicked close the corner was smaller than 1 ". It was not like that in V8x
I will place a snapshot in binary.
http://www.alibre.com/forums/viewtopic. ... 1354#11354
Schenman