How to set the mass display accuracy in the BOM. In my drawings I have one decimal place, e.g. 12.1, and in others three places, e.g. 12.124. What variable controls this?
Regards
My maintenance ends on December 25th. And I'm not going to continue it, I'm slowly finishing my professional activity. Now I have installed V24. If in the new year there are versions V24.1 V24.2… that will correct V24 errors, will I be able to install them despite the lack of maintenance?
I have been using Alibre for over 10 years and recently I realized that the backup copies of projects that I make are not copies in any sense.
Alibre gives the possibility to make a copy of model 3D in an easy way – and that works.
I was looking on the forum, I was asking my technical support...