Search results
-
M
Copy and Paste Sketches from Solidworks to Alibre Atom3D V22
Hello all. I haven't used Alibre for a few months, so I am reacquainting myself with it. The reason for that was that my old laptop was struggling with Alibre, and I had an old version of Solidworks which it could run. I've recently replaced my laptop , so I am back with Atom3D. I seem to...- mkc2862
- Thread
- atom3d v22 copy and paste sketch sketches solidworks
- Replies: 2
- Forum: General Discussion
-
M
Question regarding the Grid in Sketch mode in Atom3D.
Hello again, How do I turn the Grid off when I'm in sketch mode? Michael- mkc2862
- Thread
- Replies: 13
- Forum: General Discussion
-
M
Question regarding STEP files - which type?
Hello all, When saving files as a STEP file type, which type is best to use? I see there are two options when exporting, those being STEP AP 203 and STEP AP 214. Is one better than the other? Why are there two options? Thanks in advance. Michael- mkc2862
- Thread
- Replies: 16
- Forum: General Discussion