Search results

The patterning from extrude did not change the print to include bolt circle center lines. I saved the file as a package this time. Thank you again for your help, very much appreciated. :)

Awesome. Ok, I will go back and change the model. Thank you very much :)!

Using professional currently. I believe I created the singular hole and then used pattern for the 6 hole bottom portion. I did use singular placement for all 4 of the top holes though. If I change the tope holes to pattern will that fix it? Thank you again, your help is very much appreciated :)

Just making a new print to fix errors on this blueprint in the classroom module. This is one of many I have been redrawing for the class. Thanks for your help :)

Here is the full pdf of the classroom blueprint original as well.

Sure thing, :)

Cannot seem to figure out how to add a diameter bolt hole (B.C.) center pattern. I can add individual center marks to each hole but not the center hole pattern for the bolt circle diameter. I have it on the sketch but when I go to make the print, they disappear. Any suggestions? Thank you in...