cnc

Hello, That is what .stl file in MeshCAM looks like so far. I have been reading but... 1. How does one remove just the yellow part of the stock in the photo above? 2. I tried roughing and I tried parallel toolpaths but I am pretty sure the end result is not what I think will happen... Do I...

Hello, I found myself in the mix. This mix pertains to an Acorn CNC and router configuration of my PC. Does the Atom 3D source come with post processing or should I update to the CNC Version? Seth P.S. I would like to have Centroid Post Processing but I am probably reaching out on a limb...