Hi. I have a challenge, wonder if any do have a solution? Problem: Laying out a lot of holes in sheet metal (or just a part) in a pattern causes my Alibre to halt. I thought it was a HW problem, so checked with CPUID HW monitor open, and I noticed, that the only 2 cores seems to working a bit during the command. (Linear pattern). Checked up with normal load, including loading large assemblies, and the all cores (6) working full. Any of you know if it is software problem in Alibre or what is going here? My setup I5-8400, 32gB RAM, 2x500 Samsung EVO 970 Nvme2, graphics PNY Nvidia P2000.
(Checked also rendering in Keyshot9, there everything works to the limit, both with and without using GPU mode.)
It is a real professional problem for me, as I often need to design sheets woth a lot of patterned holes, so pls. helt me out
(Checked also rendering in Keyshot9, there everything works to the limit, both with and without using GPU mode.)
It is a real professional problem for me, as I often need to design sheets woth a lot of patterned holes, so pls. helt me out