machineitright
Member
Hi,
I am trying to place a Helical feature around a conical extrusion that the outside off the helix stays the same o.d. but the inside is at a 4.3deg draft angle and is merged with the conical solid, how do you do this? The part winds up looking like a feed auger. The helix would go around the attached file. I would appreciate any help the members could provide.
Donnie
I am trying to place a Helical feature around a conical extrusion that the outside off the helix stays the same o.d. but the inside is at a 4.3deg draft angle and is merged with the conical solid, how do you do this? The part winds up looking like a feed auger. The helix would go around the attached file. I would appreciate any help the members could provide.
Donnie