UGMENTALCASE
Member
Hi all,
I've just drafted up a job I've done with some holes in and machined pockets on the same face. In the history my counterbored hole was done first, I then did a pocket, so taking depth away from the counterbore.
I then did the drawing. Granted this may be a little back to front but that's what I did, and if you consider a mod to a tool this is what could happen.
I used the hole call out function on the drawing and it seemed to take the information from the hole dialog box in the model, and so before the pocket. So the call out wasn't correct.
Has anyone else seen this?
Yes yes, I could go back and move the hole in the tree and rearrange it all so the hole is put in after the pocket. I ended up dimensioning it all slightly different but just putting it out there incase it catches anyone else out?
I've just drafted up a job I've done with some holes in and machined pockets on the same face. In the history my counterbored hole was done first, I then did a pocket, so taking depth away from the counterbore.
I then did the drawing. Granted this may be a little back to front but that's what I did, and if you consider a mod to a tool this is what could happen.
I used the hole call out function on the drawing and it seemed to take the information from the hole dialog box in the model, and so before the pocket. So the call out wasn't correct.
Has anyone else seen this?
Yes yes, I could go back and move the hole in the tree and rearrange it all so the hole is put in after the pocket. I ended up dimensioning it all slightly different but just putting it out there incase it catches anyone else out?