oldfox
Alibre Super User
I want to check the colors of an assembly so I...
1: Click open on the home screen - assembly thumbnail screen opens
2: Click on the assembly I want
3: Click on the "OPEN" button at the bottom of the screen
4: Assembly screen opens
5: I check the colors and do absolutely nothing else. (sitting on my hands)
Colors look good.
6: I click on the close button at the upper right of screen.
And here is the issue...
The dialog screen that pops up says that I have made changes and haven't been saved. Do I want to save? Yes/No
7: I click on the No button and the assembly screen closes.
Why the extra click? When I have many assemblies in a model that I want to make that last check on colors, that can add up to many extra clicks and extra minutes, not just seconds.
1: Click open on the home screen - assembly thumbnail screen opens
2: Click on the assembly I want
3: Click on the "OPEN" button at the bottom of the screen
4: Assembly screen opens
5: I check the colors and do absolutely nothing else. (sitting on my hands)
Colors look good.
6: I click on the close button at the upper right of screen.
And here is the issue...
The dialog screen that pops up says that I have made changes and haven't been saved. Do I want to save? Yes/No
7: I click on the No button and the assembly screen closes.
Why the extra click? When I have many assemblies in a model that I want to make that last check on colors, that can add up to many extra clicks and extra minutes, not just seconds.