Hi Anyone able to assist on putting a surface on this?
K Kanon Member Jan 17, 2023 #1 Hi Anyone able to assist on putting a surface on this? Attachments Jig for ball guide for flap.AD_PKG 116.9 KB · Views: 11
DavidJ Administrator Staff member Jan 17, 2023 #2 If you want a plane on end of the peg/stud, you'll have to use a cut to square off the end first (currently it is part of a cylinder from the revolve cut).
If you want a plane on end of the peg/stud, you'll have to use a cut to square off the end first (currently it is part of a cylinder from the revolve cut).
HaroldL Alibre Super User Jan 17, 2023 #3 There are a few steps involved but here is a workflow to place a plane "near" the end of your pin. Plane on Pin End.mp4 Shared from Screencast.com www.screencast.com
There are a few steps involved but here is a workflow to place a plane "near" the end of your pin. Plane on Pin End.mp4 Shared from Screencast.com www.screencast.com
K Kanon Member Jan 27, 2023 #4 Thank you very much DavidJ and HaroldL. I appreciate it! Gentleman, I apologise for the late response.
Thank you very much DavidJ and HaroldL. I appreciate it! Gentleman, I apologise for the late response.
