Reference pat geometry in assembly

[Jarek]

Hello.
I want to create a rotating part pattern. Can I use an axis created in a part in the assembly? Reference pat geometry are invisible in the assembly.
Regards,
Jarek

 

[DavidJ]

Right click the part -> Show Reference Geometry.

 

[Jarek]

Thank you for your help, it worked
One more question.
If I have a hole in part 1 and project its sketch onto the second part and try to make a hole in this place - there is a problem. The sketch geometry is visible but cannot be caught while the hole position is defined, and this moment projection is inactive. Finally, you can do it manually. Eny suggestion?
Jarek

 

[DavidJ]

Depends exactly what you are doing - if using the hole tool, don't bother projecting the hole outline from part 1, instead apply concentric constraint between the part 1 hole outline and the node for the new hole.

 

[Jarek]

Depends exactly what you are doing - if using the hole tool, don't bother projecting the hole outline from part 1, instead apply concentric constraint between the part 1 hole outline and the node for the new hole.

Concentric constraint workink, thanks.
Jarek