TWont open, is missing a partI had to take a couple of attempts, but 'convert to sheet metal' seems to do an OK job.
I suppressed your Shell operation - that isn't needed.
That doenst work, I cant edit the single flangeI'd edit the sketch of the flange and draw it in there.
That doenst work, I cant edit the single flange
do you get a different result?
Hope you don't mind but I took the liberty of editing your model to make the changes.
It works. I had to adjust only one dimensionHello Mareike,
will this work for you?
View attachment 31117
(Please check dimension before use...)
Regards
Stefan
Is there something funny going on here?
View attachment 31146