UGMENTALCASE
Member
Hi all,
I've upgraded to v25 and just doing some mods on a job. I've added a tapped hole and when I switched between through and blind the representation changes. Gives the impression of a fine thread. I've done a drawing of it and it showed a standard metric thread.
The part is only 12mm thick, if I manually make the hole 14 deep its ok, make it 20mm deep and it switches to the fine looking thread again.
Has anyone else seen this behaviour?
Cheers
I've upgraded to v25 and just doing some mods on a job. I've added a tapped hole and when I switched between through and blind the representation changes. Gives the impression of a fine thread. I've done a drawing of it and it showed a standard metric thread.
The part is only 12mm thick, if I manually make the hole 14 deep its ok, make it 20mm deep and it switches to the fine looking thread again.
Has anyone else seen this behaviour?
Cheers