R RTschaggelar Member Apr 15, 2024 #1 Trimming should allow to trim overlapping or touching sketch lines. Under which circumstances is this operation active ?
Trimming should allow to trim overlapping or touching sketch lines. Under which circumstances is this operation active ?
R RTschaggelar Member Apr 15, 2024 #3 Actually 3 different circles intersecting each other. So, 3 single sketches. Upvote 0 Downvote
HaroldL Alibre Super User Apr 15, 2024 #4 If you want to trim intersecting circles they must be in the same sketch. Otherwise, project two of them into the active sketch and then trim the result. Can you screen shot an example of what your are attempting to do? Upvote 0 Downvote
If you want to trim intersecting circles they must be in the same sketch. Otherwise, project two of them into the active sketch and then trim the result. Can you screen shot an example of what your are attempting to do?
R RTschaggelar Member Apr 15, 2024 #5 Thanks for the solution. It works. The project into one not. I had to redraw everything. Upvote 0 Downvote