JamesMC's latest activity
-
JamesMC replied to the thread serious problem.I have had a similar issue, turned out to be weirdness with reference geometry in a sketch within one part, that was getting longer... -
JamesMC replied to the thread Starting a New Thread for the Crib Sheet and Bolts, Screws, and Studs.Haha! I drew those up!
-
-
JamesMC reacted to Stu3d's post in the thread Starting a New Thread for the Crib Sheet and Bolts, Screws, and Studs with
Like.
I found a few 230mm open ended and ring spanners suitable for M160 bolt head available for sale, up to 800mm long, weight between 38.5 &... -
JamesMC reacted to HaroldL's post in the thread Rookie to Rocking it: A Masterclass in 3D Sketching in Alibre with Like.
Konstantinos, That is a great video. I learned more about 3D sketching in this video than I could from the Help manual or practicing on...
-
I think we have concluded we cannot remove spinners. Thanks! Going to close this thread.
-
I find the spinners useful for nudging a fillet, chamfer etc. up to the point an error occurs and then back off one click.
