A script that changes a picked side to have an angle.
Ie when 3D printing for casting, you usually have somewhere between 3 and 7 degree angle on the mold side to allow the cast to release from the mold.
++ for standard threads to be applied easily. Again for 3D printing
Thanks for the write-up.
I have noticed that a little bit of wind around the printer changes the print quality. Ie someone open a door/window at the back of the workshop or it gets windy outside.
This cools down the print-head and/or material.
Sensitive little things.....
I have a design made by someone else and have the option to buy either the step or the Solidworks file
Since I'm paying which one is the better, if any of the 2 formats ?
My understanding is that the current API's does not allow for this due to limited API's access
I could be wrong as it is a while ago I looked at the API list
/k
In the latest update, the mouse pointer in a sketch needs to be right on the line and often when clicking the mouse, the mouse/pointer moves a bit and misses the line/poit etc
This is sooooooooo annoying and actually makes Alibre a pain in the b...
My co-workers laughs at me when I have loud...
as Lew said, there are standards for this. If your 3D printer has variations, you will need to accommodate that. I usually just run a tap thru after to get better final sizing.
In terms of performance hit, it should be so that all threads could be turned on/off in design explorer and you can...