Southernpedro2017
Member
Hi All
This problem has been around for a while and I have asked about this in the past.
I remember than the inter-part constraints in an Assembly sometimes create this issue.
I have had situations recently where I have modified an assembly after it has been developed into a drawing and found that when the drawing is updated the Shaded view has been lost, now only a standard view is possible.
My request is can anyone please outline exactly what constraint interaction in an Assembly creates this situation.
Thanks for your input.
Regards
Southernpedro
This problem has been around for a while and I have asked about this in the past.
I remember than the inter-part constraints in an Assembly sometimes create this issue.
I have had situations recently where I have modified an assembly after it has been developed into a drawing and found that when the drawing is updated the Shaded view has been lost, now only a standard view is possible.
My request is can anyone please outline exactly what constraint interaction in an Assembly creates this situation.
Thanks for your input.
Regards
Southernpedro