I don't seem to have the 'project to sketch' feature in Atom. A search in the search bar comes up with nothing. There does not seem to be any references between the different parts when one is 'active'.
Thanks for the reply!
The $550 is the cost to upgrade from Atom. Harold was most helpful. I must not have explained what I am trying to do very well. I am making the small part that will screw onto the tube, but can not figure out how to make two screw holes that are not perpendicular. Is there...
Please look at the assembly drawing as then my question should be obvious. The part Optic Holder will be screwed to the can wall with three screws. The shown hole was easy as it is simply perpendicular to the can wall. However, the other two holes will need to be at an angle so the screw heads...
I attached two almost identical drawings. One has an error with a sweep and the other does not. The only difference is the location and size of the circle Sketch To Sweep. I also tried a different plane so the circle is centered on the Path. I'm just a bit confused.
Thanks
This drawing was modified from another. I reduced the height of the box. Now there is a piece floating above the radius cut and I can not figure out how to delete it. I can find both the faces, lines, and vertices that make it up and it is on plane 'Antenna Hole Material' but none will delete. I...
Is it possible to take a 3D layer and lay it flat into a 2D drawing so I can make a template to cut it out? I need to make a pattern to cut and form sheet metal into a funnel cone.
Thanks