Mika
Senior Member
Hi.
If I'll make my weldment structure assy drawing in a sheet 1 of 3 and want to make 2 of 3 as "cutlist". What is the best way to bring those assembly parts on that sheet separately from the assembly?
Putting those as a new views from partfiles, will change my drawing sheet name, so that is not so good way. Adding the whole assembly as a new view and hiding the all other parts than wanted one piece of "flatbar" makes better solution.
When doing like this, I just cannot get the "flat patterns" of sheet metal parts used in a weldment assembly. I just want to show all the weldment assy parts separately on a one sheet, sheet 2 of 3 as "cutlist". Not a separated drawings from each piece of metal.
Sheet 3 of 3 will be the scale 1:1, named as DXF. Ready to export for laser cut.
1 of 3: Weldment assy
2 of 3: Cutlist
3 of 3: DXF
If I'll make my weldment structure assy drawing in a sheet 1 of 3 and want to make 2 of 3 as "cutlist". What is the best way to bring those assembly parts on that sheet separately from the assembly?
Putting those as a new views from partfiles, will change my drawing sheet name, so that is not so good way. Adding the whole assembly as a new view and hiding the all other parts than wanted one piece of "flatbar" makes better solution.
When doing like this, I just cannot get the "flat patterns" of sheet metal parts used in a weldment assembly. I just want to show all the weldment assy parts separately on a one sheet, sheet 2 of 3 as "cutlist". Not a separated drawings from each piece of metal.
Sheet 3 of 3 will be the scale 1:1, named as DXF. Ready to export for laser cut.
1 of 3: Weldment assy
2 of 3: Cutlist
3 of 3: DXF